Create Your Hotspot In “PC” without using any Third-Party Software’s…

Featured

Hello guys,,here TechNerd91 ..

“CMD” Command Prompt is just awesome thing you can do lot’s of thing’s using this ,
Today we are doing some cool stuff using “CMD“…….

You don’t need any third-party Software’s to create “Wi-Fi hotspot” to share your PCs internet ,You Can do it by just putting some “Command’s” in Command Prompt “CMD“..

So let’s get start…………………….

In the Command Prompt, enter the following command to enable Wi-Fi Hotspot.

(“ netsh wlan set hostednetwork mode=allow ssid=Hotspotname key=password ”)

You Can give any Name to your ssid in Place of “Hotspotname” type anything you want and set any “Password” you want,Like below Following,,,,,,.⇓⇓⇓

(“ netsh wlan set hostednetwork mode=allow ssid=TechNerd91 key=12345678”)

Once enabled, you can start the Wi-Fi  hotspot by entering the  following command…….

To Start HotSpot Enter Below Command ↓↓

(” netsh wlan start hostednetwork “)

To Stop HotSpot Enter Below Command ↓↓

(” netsh wlan stop hostednetwork “)


You will also need to share your internet connection to this hotspot for everyone to use…For This,

  • Go to “Network and Sharing” option from the “Control Panel” and then click on “Change adaptor settings” in the left panel…..,
  • Here, right click on the internet connection you are using and click on “Properties
  • In the properties, go to sharing tab and check the option “Allow other network users to connect through this computer’s internet connection” to share your internet connection.